Monoprice Voxel 3D Printer: Difference between revisions

@@ Line 1: / Line 1: @@
 The [https://www.monoprice.com/product?p_id=33820 Monoprice Voxel] is an affordable 3D printer using 1.75mm filament.
-It claims to support 3MF, STL, OBJ, FPP, BMP, PNG, and JPG.
+It claims to support 3MF, STL, OBJ, FPP, BMP, PNG, and JPG via its slicing software; GX and G are directly supported.
 ==Calibration==
 * Enter calibration mode using the on-screen display.
-* Lay a piece of paper atop the removable build plate, underneath the nozzle.
+* The nozzle will be lowered by the device.
-* Use up/down controls to lower the nozzle until it is touching the paper (i.e. immediately before the nozzle deforms the paper)
+* Fine-tune the nozzle until a piece of paper can just slide underneath it.
+** Use the up and down buttons on the touchscreen