Check out my first novel, midnight's simulacra!
Monoprice Voxel 3D Printer: Difference between revisions
From dankwiki
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
The [https://www.monoprice.com/product?p_id=33820 Monoprice Voxel] is an affordable 3D printer using 1.75mm filament. It is said to be a rebranded [https://flashforge-usa.com/products/adventurer-3 FlashForge Adventurer 3], which seems plausible from external appearance. I believe it to have "Sailfish" flavored GCode. | The [https://www.monoprice.com/product?p_id=33820 Monoprice Voxel] is an affordable 3D printer using 1.75mm filament. It is said to be a rebranded [https://flashforge-usa.com/products/adventurer-3 FlashForge Adventurer 3], which seems plausible from external appearance. I believe it to have "Sailfish" flavored GCode. | ||
The build area is 150mm x 150mm x 150mm. | |||
It claims to support 3MF, STL, OBJ, FPP, BMP, PNG, and JPG via its slicing software; GX and G are directly supported. | It claims to support 3MF, STL, OBJ, FPP, BMP, PNG, and JPG via its slicing software; GX and G are directly supported. | ||
Revision as of 22:13, 26 October 2019
The Monoprice Voxel is an affordable 3D printer using 1.75mm filament. It is said to be a rebranded FlashForge Adventurer 3, which seems plausible from external appearance. I believe it to have "Sailfish" flavored GCode.
The build area is 150mm x 150mm x 150mm.
It claims to support 3MF, STL, OBJ, FPP, BMP, PNG, and JPG via its slicing software; GX and G are directly supported.
Calibration
- Enter calibration mode using the on-screen display.
- The nozzle will be lowered by the device.
- Fine-tune the nozzle until a piece of paper can just slide underneath it.
- Use the up and down buttons on the touchscreen
