Check out my first novel, midnight's simulacra!

CODI6: Difference between revisions

From dankwiki
No edit summary
No edit summary
Line 1: Line 1:
[[File:Codi6.svg|thumb|right|functional diagram]]
[[File:Codi6.svg|thumb|right|functional diagram]]
An ARGB/PWM controller from Gelid, based around an Arduino Uno clone. Each 5V channel can put out 4A (though the SATA power connector can only carry 4.5A total of 5V power in...).
An ARGB/PWM controller from Gelid, based around an Arduino Uno clone plus a shield with 12V PWM and 5V ARGB outputs (six of each). Each 5V channel is documented as capable of putting out 4A (though the SATA power connector can only carry 4.5A total of 5V power in...). All the shield's outputs are powered by the mandatory SATA power; power supplied to the board cannot drive these outputs.


What exactly is https://github.com/notabucketofspam/ARGB?
What exactly is https://github.com/notabucketofspam/ARGB?
Line 13: Line 13:
* a function button
* a function button


I'm not sure which, if any, PWM receptacles passes on a tach signal for return.
I'm not sure which, if any, of the PWM receptacles passes on a tach signal for return.


==Pin to functional element mapping==
==Pin to functional element mapping==

Revision as of 00:44, 9 November 2022

functional diagram

An ARGB/PWM controller from Gelid, based around an Arduino Uno clone plus a shield with 12V PWM and 5V ARGB outputs (six of each). Each 5V channel is documented as capable of putting out 4A (though the SATA power connector can only carry 4.5A total of 5V power in...). All the shield's outputs are powered by the mandatory SATA power; power supplied to the board cannot drive these outputs.

What exactly is https://github.com/notabucketofspam/ARGB?

The shield

The shield has six rows of interfaces:

  • A 5-pin receptacle coupled to a custom cable (this cable has a 4-pin PWM (fan) plug and a male SATA power plug), and a 4-pin hookup for an ultrasonic sensor.
  • 3x 5V 3-pin ARGB receptacles
  • 3x 12V 4-pin PWM receptacles
  • 3x 5V 3-pin ARGB receptacles
  • 3x 12V 4-pin PWM receptacles
  • a function button

I'm not sure which, if any, of the PWM receptacles passes on a tach signal for return.

Pin to functional element mapping

(bottom is opposite the USB/power jack)

  • Pin 3 maps to the bottom leftmost ARGB hookup
  • Pin 5 maps to the bottom center ARGB hookup
  • Pin 6 maps to the bottom rightmost ARGB hookup
  • Pin 9, 10, and 11 map to the upper ARGB hookups