Check out my first novel, midnight's simulacra!
Monoprice Voxel 3D Printer: Difference between revisions
From dankwiki
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
The [https://www.monoprice.com/product?p_id=33820 Monoprice Voxel] is an affordable 3D printer using 1.75mm filament. | The [https://www.monoprice.com/product?p_id=33820 Monoprice Voxel] is an affordable 3D printer using 1.75mm filament. | ||
It claims to support 3MF, STL, OBJ, FPP, BMP, PNG, and JPG. | It claims to support 3MF, STL, OBJ, FPP, BMP, PNG, and JPG via its slicing software; GX and G are directly supported. | ||
==Calibration== | ==Calibration== | ||
* Enter calibration mode using the on-screen display. | * Enter calibration mode using the on-screen display. | ||
* | * The nozzle will be lowered by the device. | ||
* Use up | * Fine-tune the nozzle until a piece of paper can just slide underneath it. | ||
** Use the up and down buttons on the touchscreen | |||
Revision as of 21:42, 26 October 2019
The Monoprice Voxel is an affordable 3D printer using 1.75mm filament.
It claims to support 3MF, STL, OBJ, FPP, BMP, PNG, and JPG via its slicing software; GX and G are directly supported.
Calibration
- Enter calibration mode using the on-screen display.
- The nozzle will be lowered by the device.
- Fine-tune the nozzle until a piece of paper can just slide underneath it.
- Use the up and down buttons on the touchscreen
