Check out my first novel, midnight's simulacra!

Monoprice Voxel 3D Printer

From dankwiki
Revision as of 22:13, 26 October 2019 by Dank (talk | contribs)

The Monoprice Voxel is an affordable 3D printer using 1.75mm filament. It is said to be a rebranded FlashForge Adventurer 3, which seems plausible from external appearance. I believe it to have "Sailfish" flavored GCode.

The build area is 150mm x 150mm x 150mm.

It claims to support 3MF, STL, OBJ, FPP, BMP, PNG, and JPG via its slicing software; GX and G are directly supported.

Calibration

  • Enter calibration mode using the on-screen display.
  • The nozzle will be lowered by the device.
  • Fine-tune the nozzle until a piece of paper can just slide underneath it.
    • Use the up and down buttons on the touchscreen