Check out my first novel, midnight's simulacra!

Winbond: Difference between revisions

From dankwiki
Line 2: Line 2:


==[https://www.winbond.com/resource-files/w25n01gv%20revg%20032116.pdf W25N01GV]==
==[https://www.winbond.com/resource-files/w25n01gv%20revg%20032116.pdf W25N01GV]==
A 1Gb (128MB) Quad-SPI SLC NAND chip of 1K 128KB blocks (each made up of 64 2KB pages), capable of up to 104MHz Quad-SPI. Each page, in addition to the 2048 usable bytes, contains a 64-byte "Spare Area". The first 16 bytes of each Spare Area is used for ECC and bad block marking.
A 1Gb (128MB) Quad-SPI SLC NAND chip of 1K 128KB blocks (each made up of 64 2KB pages), capable of up to 104MHz Quad-SPI. Each page, in addition to the 2048 usable bytes, contains a 64-byte "Spare Area". The majority of the Spare Area is used for ECC and bad block marking, though 2 unprotected and 4 ECC-protected bits are available to the user in each of 4 16-byte lines.  


Packagings include:
Packagings include:

Revision as of 03:40, 29 March 2019

Winbond of Taiwan manufactures semiconductor devices, including flash storage.

W25N01GV

A 1Gb (128MB) Quad-SPI SLC NAND chip of 1K 128KB blocks (each made up of 64 2KB pages), capable of up to 104MHz Quad-SPI. Each page, in addition to the 2048 usable bytes, contains a 64-byte "Spare Area". The majority of the Spare Area is used for ECC and bad block marking, though 2 unprotected and 4 ECC-protected bits are available to the user in each of 4 16-byte lines.

Packagings include:

  • 8-pad WSON 8x6mm (package code ZE)
  • 16-pin SOIC 300-mil (package code SF)
  • 1x4 + 4x5 24-ball 8x6mm TFBGA (package code TB)
  • 4x6 24-ball 8x6mm TFBGA (package code TC)

Lines:

  • CLK serial clock input
  • /CS chip select input
    • High deselects the device, putting it into standby mode (reduced power consumption)
    • Transition to low places device into active mode
    • /CS must track VCC during initialization and shutdown
  • DI (IO0) data input / data io0
  • DO (IO1) data output / data io1
  • /WP (IO2) write protect input / data io2
  • /HOLD (IO3) hold input / data io3
  • VCC power (2.7V--3.6V)
  • GND

/WP and /HOLD are only for SPI/Dual-SPI (Quad-SPI uses data io 0--3). Data is always written on the rising edge of CLK, and read on the falling edge. SPI must write through DO and read through DI. Dual- and Quad-SPI treat data io pins as bidirectional.