Gigabyte Aorus Master TRX40

The Aorus Master TRX40 from Gigabyte is a TRX40 motherboard supporting third-generation Threadrippers from AMD.

Sensors

The Aorus Master sports (supposedly) an IT8688E and an IT8792E I/O Super I/O chip. The it87 module shipped in the Linux kernel as of at least 5.17.13 will load, recognizing an IT8733E:

[ 4321.190178] it87: Found IT8733E chip at 0xa60, revision 3
[ 4321.190213] it87: Beeping is supported

not much useful is recognized by this driver. If one instead uses Frank Crawford's fork, by default the driver will recognize a IT8792E/IT8795E:

[ 5418.264481] it87: Found IT8792E/IT8795E chip at 0xa60, revision 3
[ 5418.264512] it87: Beeping is supported

one can force recognition of an IT8688E by supplying the parameters force_id=0x8688 ignore_resource_conflict=1, but these don't seem to provide a different result vis-à-vis lm_sensors, while generating nastygrams in dmesg.

Either way, I get six temperature reports and five fan reports, along with some electrical data:

it8686-isa-0a40
Adapter: ISA adapter
in0:           1.01 V  (min =  +0.00 V, max =  +3.06 V)
in1:           2.03 V  (min =  +0.00 V, max =  +3.06 V)
in2:           2.05 V  (min =  +0.00 V, max =  +3.06 V)
in3:           2.03 V  (min =  +0.00 V, max =  +3.06 V)
in4:           1.37 V  (min =  +0.00 V, max =  +3.06 V)
in5:           1.09 V  (min =  +0.00 V, max =  +3.06 V)
in6:           1.37 V  (min =  +0.00 V, max =  +3.06 V)
3VSB:          3.34 V  (min =  +0.00 V, max =  +6.12 V)
Vbat:          3.17 V  
fan1:        4720 RPM  (min =   10 RPM)
fan2:        1205 RPM  (min =    0 RPM)
fan3:           0 RPM  (min =    0 RPM)
fan4:           0 RPM  (min =    0 RPM)
fan5:         745 RPM  (min =    0 RPM)
temp1:        +35.0°C  (low  = +127.0°C, high = +127.0°C)  sensor = thermistor
temp2:        +48.0°C  (low  =  +0.0°C, high = +90.0°C)  sensor = thermistor
temp3:        +42.0°C  (low  =  +0.0°C, high = +90.0°C)  sensor = AMD AMDSI
temp4:        +42.0°C  (low  = +127.0°C, high = +127.0°C)  sensor = thermistor
temp5:        +33.0°C  (low  =  +0.0°C, high = -125.0°C)  sensor = thermistor
temp6:        +27.0°C  (low  = +127.0°C, high = +127.0°C)  sensor = thermistor
intrusion0:  OK

I'm pretty sure that temp6 is external temp sensor 2 (EXTEMP2). External temp sensor 1 doesn't seem to be included. fan1 definitely appears to be CPU0.