Bambu Carbon X1C: Difference between revisions
No edit summary |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
The X1 occupies an area of 389mm² and has a height of 457mm. | The X1 occupies an area of 389mm² and has a height of 457mm. | ||
I have a page about [[Filaments|Bambu filaments]]. | |||
==[[MQTT]]== | ==[[MQTT]]== | ||
| Line 72: | Line 74: | ||
===Electronics=== | ===Electronics=== | ||
I'll be adding an [ | I'll be adding an [[ESP32]] plus: | ||
* DS18B20 [https://en.wikipedia.org/wiki/1-Wire 1-Wire] temperature sensor | * DS18B20 [https://en.wikipedia.org/wiki/1-Wire 1-Wire] temperature sensor | ||
* a HiLetgo 3-01-0340 5V relay | * a HiLetgo 3-01-0340 5V relay | ||
| Line 78: | Line 80: | ||
* an SSD1306 OLED display | * an SSD1306 OLED display | ||
* a 60C normally-closed temperature switch | * a 60C normally-closed temperature switch | ||
* a 120VAC -> 12V | * a 120VAC -> 12V 2A AC adapter | ||
* | * a 120VACV ceramic heating element | ||
* a LMS2596 buck converter taking 12V to 5V | * a LMS2596 buck converter taking 12V to 5V | ||
* | * a CCS811 VOC sensor | ||
The AC adapter theoretically offers 120W, but it's safer to assume no more than 90W (¾ of the rated output). This will be used to drive our heating elements and fans. The Arduino itself is powered off the AMS circuit. Leaving aside peripherals, it ought not draw more than 125 mA, even when transmitting on wireless. This ought be safe, and is less than our fans were previously drawing from the AMS. Remember, Bambu doesn't guarantee any slack on the AMS circuit, and expressly instructs you not to draw from it. | The AC adapter theoretically offers 120W, but it's safer to assume no more than 90W (¾ of the rated output). This will be used to drive our heating elements and fans. The Arduino itself is powered off the AMS circuit. Leaving aside peripherals, it ought not draw more than 125 mA, even when transmitting on wireless. This ought be safe, and is less than our fans were previously drawing from the AMS. Remember, Bambu doesn't guarantee any slack on the AMS circuit, and expressly instructs you not to draw from it. | ||
| Line 93: | Line 96: | ||
====Details==== | ====Details==== | ||
We use pin D2 for the fan tachometer, employing a hardware interrupt. We use pin D3 for the 25KHz fan PWM, employing hardware PWM. The DS18B20 is read on D4. The relay is controlled via D5 | We use pin D2 for the fan tachometer, employing a hardware interrupt. We use pin D3 for the 25KHz fan PWM, employing hardware PWM. The DS18B20 is read on D4. The relay is controlled via D5. D14 (SDA) and D15 (SCL) control the CCS811 using I2C. | ||
[[CATEGORY: Hardware]] | [[CATEGORY: Hardware]] | ||
[[CATEGORY: Projects]] | [[CATEGORY: Projects]] | ||
[[CATEGORY: 3D | [[CATEGORY: 3D Printing]] | ||