InaMORata 2.0: Difference between revisions
| Line 29: | Line 29: | ||
* On/off switch takes 12V to SATA and buck converter | * On/off switch takes 12V to SATA and buck converter | ||
** The two sets of three wires are connected with two heatshrink solder tubes | ** The two sets of three wires are connected with two heatshrink solder tubes | ||
* Buck converter takes 5V to SATA | * Buck converter takes 5V to SATA and USB-C pigtails | ||
** The two sets of | ** The two sets of three wires are connected with two heatshrink solder tubes | ||
* USB-C takes 5V to ESP32 | |||
* SATA takes 12V+5V to SATA splitter | * SATA takes 12V+5V to SATA splitter | ||
* SATA splitter takes 12V+5V to CODI6 + SATA splitter | * SATA splitter takes 12V+5V to CODI6 + SATA splitter | ||
* SATA splitter takes 12V to 2x pumps | * SATA splitter takes 12V to 2x pumps | ||
* CODI6 takes 12V (via fan hookup) and 5V (via ARGB hookup) to 3x rightmost fans | * CODI6 takes 12V (via fan hookup) and 5V (via ARGB hookup) to 3x rightmost fans | ||
* 3x rightmost fans take 12V+5V to corresponding 3x middle fans | * 3x rightmost fans take 12V+5V to corresponding 3x middle fans | ||
* 3x middle fans takes 12V+5V to corresponding 3x leftmost fans | * 3x middle fans takes 12V+5V to corresponding 3x leftmost fans | ||
We don't need to expose the 5V to the pumps, but it doesn't hurt anything. The CODI6 has a 5-pin wire, where three pins (12V, 5V, ground) go to a SATA connector, and two pins (tach, pwm) go to a 4-hole Molex fan connector. This connector doesn't carry 12V or ground like a 4-wire Molex would. | We don't need to expose the 5V to the pumps, but it doesn't hurt anything. The CODI6 has a 5-pin wire, where three pins (12V, 5V, ground) go to a SATA connector, and two pins (tach, pwm) go to a 4-hole Molex fan connector. This connector doesn't carry 12V or ground like a 4-wire Molex would. | ||
At this point, we have three hookups unconnected: the three Molex 4-hole connectors coming off the pumps and CODI6. Each has a tach and PWM signal, and none are drawing power. Hook them up to the perfboard's Molex 4-pin headers. | At this point, we have three hookups unconnected: the three Molex 4-hole connectors coming off the pumps and CODI6. Each has a tach and PWM signal, and none are drawing power. Hook them up to the perfboard's Molex 4-pin headers. | ||